Liquid Nails Landscape

1. Ensure the surface is sound, dry and free from oil, grease and loose powdery material (if necessary, use mineral turpentine to clean the surface and allow to dry).
2. Cut cartridge tip, fit nozzle and cut nozzle to a suitable size opening (approximately 5mm) then insert into a caulking gun.
3. Using the caulking gun, apply ‘dobs’ or ‘beads; of adhesive of appropriate thickness to ensure sufficient contact and spread between both surfaces. (To minimise ‘squeeze out’ apply at least 12mm in from edges).
4. Immediately bring surfaces together before product skins (within 5 minutes) and apply sufficient pressure to spread adhesive between both surfaces
5. Do not wipe excess ‘squeeze out’. Wait until product cures and remove by trimming with a sharp blade, but avoid cutting into bond.
6. Leave undisturbed until adhesive cures sufficiently. Do not allow traffic on stairs or use walls for at least 24 hours.

        Limitations:

• Not for soft or crumbly materials.
• Not recommended for permanent water immersion applications.
• Can not be painted over.
• Liquid Nails Landscape cannot be used as a contact adhesive.
• New concrete will not adhere to cured adhesive.
• Do not use as the sole bonding agent for structural bonding
• Not for permanent water immersion.
• Not for use on polyethylene, polypropylene or Teflon. 

• If repositioning materials, fresh adhesive must be applied to achieve bonding.
• Working time is 10 minutes. Ensure surfaces are brought together before this time.
• Spilt or smeared adhesive is best left to cure and then remove by abrasion.

• Uncured product may be removed with mineral turps.
• Cured product can be removed with Selleys(R) Silicone Remover or by
  mechanical action.