Selleys Fix&Go High Precision Bottle Super Glue

1. Ensure surfaces to be bonded are clean, dry, free of dust, and close fitting.
2. Hold tube upright and without applying pressure, pierce seal at end of tube by attaching nozzle and cap and turning clockwise.
3. Remove cap and apply a small amount of glue to one surface. Bring surfaces together and apply slight pressure. The product grabs within 10 seconds, depending on environmental conditions and materials to be bonded. Allow 30 minutes for sufficient bond strength for practical use. Bond will strengthen over 12 hours.
4. Wipe tip of tube, replace cap and store upright in a dry cool place.

Limitations:

• *Not suitable for bonding plastics such as Polypropylene and Polyethylene. Use Selleys All Plastics.
• Not recommended for glass. Use Selleys Araldite Ultra Clear.
• Not suitable for repairing items that are in direct contact with hot liquids eg saucepans.
• Will not permanently bond materials containing alkaline elements.
• Has no gap filling properties therefore surfaces need to be a close fit.
• Not recommended for highly porous surfaces.
• May cause some leather to harden or discolour. Pre-test on inconspicuous area.
• Water resistant not water proof, therefore not suitable for surfaces that will be continually wet.

• To use the glue saver nozzle, before completely dispensing a drop of Super Glue, release pressure on the dispenser buttons and the glue saver will retract the glue back into the bottle.
• Excellent when used with other adhesives, as a temporary tack
  In the event that fingers get stuck together, apply a solvent such as acetone to contact areas then wash off with water. Do not use solvents near eyes or open wounds.
• Since Super Glue cures with moisture set times may be extended on very dry surfaces or under dry conditions.
• Super Glues cure more lowly when large amounts are used. For faster cure use sparingly.

• Uncured product may be removed with acetone.
• Cured product can be sanded and scraped.