Autofix Instant Gasket High Temperature Red

1. Use in well ventilated areas and avoid contact with skin and eyes. Thoroughly clean surfaces with mineral turpentine and dry.
2. Pierce seal in tube, fit nozzle and cut to size.
3. For use as an adhesive, apply sufficiently to one surface only and bring together within 4 minutes and fasten immediately. If fasteners are not being used, support joint until sealant cures.
4. For use as a joint or seam sealant, mask adjacent surfaces and apply sealant so that it completely fills the joint and makes contact with both surfaces. Tool immediately with a spatula dipped in detergent water, forcing sealant into the joint and remove masking tape before sealant skins (5 min).
5. For use as a surface sealant, apply sealant and tool evenly to desired thickness before sealant skins (5 min).
6. Clean up with turps before sealant cures. Remove nozzle and replace cap. Allow sealant to cure in nozzle and remove before next use.

        Limitations:

• Not suitable for polycarbonate, polyethylene or polypropylene plastics.
• Sealant cannot be painted over.
• Not recommended for below waterline applications.

• Resistant to -60ºC and 180ºC continuously, or to 240ºC intermittently.
• Product releases methyl ethyl ketoxime while curing.

• Uncured product may be removed with mineral turpentine.
• Cured product can be removed by cutting and scraping.